Oil stone box(2)

It is very essential that the object has to fix,when we use hand tools for woodworking. Using G-clamp is one of the easiest way and need 2 scraps to protect the object form press of the clamp.




Mr Lim! Where is your g clamp?

 
Removing the outline area. 90 degree angle from the wood and hit the top of chise with a hammer(do not use your head). We should be careful about grains ,otherwise the timber may split.

This is the profile view and  we had to think about the deepth reagarding the size of each oil stones. Also,we needed to make sure that there were small gaps between the upper wood and the oilstone, however, the oilstone should be stuck in the bottom.                                                  The last picture on the blackboard shows how to  use 'Plunge router' - because it is quite difficult to control, we should start from the middle and slowly move it clockwise direction and make the rounds bigger and bigger. We have to keep press this router in same strength, if not the floor will not be flat also, if we move it too slowly, the timber will burn(I like the smell tough^^)