Small craft(8)

  We glued and clamped the hull on the chine and the keel. We had to glue from the front(bow part), because of a huge tension. If glued from the transom, it would be very hard to band or causing a cracking.  

We had to use scarfing again for joining the bottom and the side. The chine line starts clearly from the transom, but the middle of bow, it becomes vague and finally, it is finished smoothly at the stem. That's why we had to find the intersecting point of two timbers(bottom and side). Also, the point must be same on the opposite side. To make sure, we made right angle cuts on the both of the timbers and fitted them together. We gave some beveling on the both of overlap parts before glue them.







 We fixed with nails



Removed all of offcut between the bottom and the side with a block plane and sandpapers to make perfect sharp chine lines.