Boat Construction (4)

I made doublers for fitting in the basin and set it up on the right palce. Plus, I made a basin cover too.

Over the my basin side of bulkhead, the cockpit is placed, and underneath of that water pipes are going to  be installed. That's why I made two holes and create smaller room for electic wirings.

Additionally, I built one more shelf insde the basin to gain enough storage.  

During the job, I made a mistake that I sanded the edges too much. It became too small to fit.  As a result, I had to make the basin shelf again which would be bigger than mistake one. To making right size of shelf quickly, I used a transfer skill that is measuring outfit with a small stick and transfer to other timber.

1. Check how much need to extend.
    Prepare a small stick.

2. Put down the stick on the timber and make sure its end touches the wall. Draw the outline of the stick.

3. Draw several more out line of the stick in same procedure  along the outshape.

4. Lay the timber down onto new timber which is going to transfer. Put the stick on following out lines. Mark the edge of stick. Link all these marks.

I made doublers along the bulkhead and small room. I also attached short doublers on the hull and inside the basin.